AddAudioModesis used to build and remove a list of audio modes that AHI can understand. The definitions of the audio modes are stored in `DEVS:Audiomodes' (see section The Mode Descriptors). Normally you don't have to run this program, since
ahi.deviceautomatically reads all mode descriptors when it is used for the first time. It can, however, be useful in installation scripts. The `FILES' option specifies with descriptor(s) to be added to the current mode list. The `QUIET' option, if specified, will suppress error and output messages. The `REFRESH' option, if specified, will scan `DEVS:Audiomodes' and add all descriptors found there to the current mode list. The `REMOVE' option, if specified, will flush the current audio mode list from memory. The `DBLSCAN' option does not have anything to do with the audio mode list. If specified, it will open and then immediately close a native, double-scan screen. On some systems using a graphic card, this will enable >28 kHz sample frequencies with the native audio. You need an appropriate monitor driver in `DEVS:Monitors' to make it work.
Go to the first, previous, next, last section, table of contents.